Stove Usage, Safety and Paint Curing Guide

Your stove has a high-temperature powder coat that requires careful handling until fully cured.

Always cure the paint outdoors.

1. First Burn
   Start with a small fire using mainly kindling.
   Burn for about 15 minutes.
   The paint is soft at this stage, so avoid touching the surface or placing pans on it.
2. Cool Down
   Let the stove cool completely after the first burn.
3. Second Burn
   Build a medium-sized fire.
   Allow it to burn, then cool completely.
4. Final Burn
   Start with a small fire, gradually adding fuel to build a steady burn.
   Maintain the fire for about an hour.
   The paint will set as the stove cools.

Note : During curing, the paint may emit an odor and/or some smoke. This is normal and marks the start of your stove's long journey with you.

Important: Perform all curing burns outdoors.

1. Fire Safety:
   Always keep a fire extinguisher nearby when operating the stove.
   Install a carbon monoxide alarm and smoke detector for early warning of harmful emissions.
2. Fuel Use:
   Only burn wood. Do not use the stove as an incinerator or burn general waste.
   Avoid using liquid fuels to light the stove. Follow the fuel and lighting instructions for optimal performance.
3. Handling:
   Stoves become extremely hot—handle with care.
   Never leave the stove unattended.
   Keep children and pets away from the stove and flue to prevent burns.
4. Ventilation:
   Ensure proper ventilation, as fires consume oxygen and emit harmful gases.
   Position the stove's flue to direct emissions safely away from the area.
   Always use your stove responsibly and with common sense.

Fuel 

• Use only kiln-dried wood with a moisture content below 20%.
• Do not burn wet or unseasoned wood, construction timber, painted/treated wood, driftwood, or manufactured boards. These materials burn inefficiently, produce excess smoke and tar, and can damage your stove, flue, and tent. They may also cause a chimney fire.
• Avoid burning bituminous coal, petroleum-based products, or liquid fuels.

Building the Fire 

• Build the fire at the front of the stove using small, bone-dry wood.
• Start small and allow the fire to heat the flue to ensure proper smoke ventilation.
• Avoid overloading the stove with fuel at the start.
• Keep the door slightly ajar to improve airflow until the fire is established.

Curing Your Stove Paint (Read Before First Use)

• Curing must be done outdoors. During curing, the paint will emit an odor. This is normal and marks the stove’s initial use.
• First burn: Start a small fire (mainly kindling) and burn for 15 minutes. Avoid touching the stove or using pans during this time. Let the stove cool completely afterward.
• Second burn: Build a medium-sized fire and let it burn, then cool completely.
• Final burn: Start with a small fire, gradually adding fuel, and let it burn for about an hour. The paint sets as the stove cools.

Installation

• If installing in a tent or shed, use the correct flashing kit and follow all safety precautions.
• Ensure adequate ventilation and prioritize safety, especially for first-time stove users.

Maintain these minimum distances from combustible materials:

• Side: 60 cm
• Rear: 60 cm
• Top: 100 cm

Hot Surfaces

The stove and flue get extremely hot during use. Use a fireguard if children or vulnerable adults are present.

Alarms

Always use a carbon monoxide alarm when operating the stove in a tent.